inc500
  • MN Type III emtek access
  • 3 beam rig mat
  • TMS SLIDE 10-Bamboo
  • emtek mat with loader
  • emtek df bridge beams
  • 3ply fingered pad
  • ttxl pad
  • ET fingered 3ply
  • 12″ mats with crane boom
  • 12″ with crawler crane

Exploration

The earliest oil wells were drilled percussively by hammering a cable tool into the earth. Soon after, cable tools were replaced with rotary drilling, which could drill boreholes to much greater depths and in less time. The record-depth Kola Borehole used non-rotary mud motor drilling to achieve a depth of over 12,000 meters (38,000 ft).

Until the 1970s, most oil wells were vertical (although different lithology and mechanical imperfections cause most wells to deviate at least slightly from true vertical). However, modern directional drilling technologies allow for strongly deviated wells which can, given sufficient depth and with the proper tools, actually become horizontal. This is of great value as the reservoir rocks which contain hydrocarbons are usually horizontal, or sub-horizontal; a horizontal wellbore placed in a production zone has more surface area in the production zone than a vertical well, resulting in a higher production rate.

The use of deviated and horizontal drilling has also made it possible to reach reservoirs several kilometers or miles away from the drilling location (extended reach drilling), allowing for the production of hydrocarbons located below locations that are either difficult to place a drilling rig on, environmentally sensitive, or populated.